| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: reinstate IEEE80211_TX_CTL_AMPDU flag in ieee80211_tx_prep_agg()
The commit 592234e941f1 ("wifi: mac80211: Fix iTXQ AMPDU fragmentation
handling") changed the way handling of the IEEE80211_TX_CTL_AMPDU flag
is done in mac80211, so the only place it is set is in
ieee80211_tx_dequeue().
This means that any frames that are sent to the driver via drv_tx() will
no longer have the flag set. In particular, this affects packets going
through ieee80211_tx_pending(). Evan reported that this can result in
the ath9k driver failing to account such packets in its block ack
window, eventually overrunning the window and stalling TX.
Fix this by reinstating the flag in ieee80211_tx_prep_agg() when inside
a valid block ack window. This should be harmless for the TXQ path, and
will reinstate the previous behaviour for drivers that use the flag as a
signal to track the packet in the window. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: Publish the output fence outside of job_lock
job_lock is taken by the V3D interrupt handler, so nesting an IRQ-unsafe
lock under it creates an inversion. drm_syncobj_replace_fence() takes
drm_syncobj::lock, which other paths acquire with interrupts enabled. For
example, a thread interrupted while holding it blocks the handler on
job_lock, and the handler can only make progress once the submit path
releases job_lock, which it cannot do while waiting for drm_syncobj::lock.
This is reported by lockdep:
[ 188.139076] ========================================================
[ 188.139086] WARNING: possible irq lock inversion dependency detected
[ 188.139096] 7.3.0-rc3-00067-gc4f3feeaf60f #67 Tainted: G C
[ 188.139108] --------------------------------------------------------
[ 188.139116] swapper/0/0 just changed the state of lock:
[ 188.139125] ffff0000054f8ff8 (&vc4->job_lock){-...}-{3:3}, at: vc4_irq+0xa8/0x28c [vc4]
[ 188.139234] but this lock took another, HARDIRQ-unsafe lock in the past:
[ 188.139242] (&syncobj->lock){+.+.}-{3:3}
[ 188.139256] and interrupts could create inverse lock ordering between them.
[ 188.139267] other info that might help us debug this:
[ 188.139275] Possible interrupt unsafe locking scenario:
[ 188.139284] CPU0 CPU1
[ 188.139291] ---- ----
[ 188.139299] lock(&syncobj->lock);
[ 188.139312] local_irq_disable();
[ 188.139320] lock(&vc4->job_lock);
[ 188.139335] lock(&syncobj->lock);
[ 188.139350] <Interrupt>
[ 188.139358] lock(&vc4->job_lock);
[ 188.139372] *** DEADLOCK ***
Hand the fence over after job_lock is dropped. The job can complete and
drop exec->fence in that window, so take a reference first and publish
through the local pointer, as exec may already be gone. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: reload TDLS header pointer after skb_linearize()
ieee80211_process_tdls_channel_switch() sets tf = skb->data before it
calls skb_linearize(), and reads tf->action_code afterwards.
ieee80211_rx_h_data() queues TDLS channel switch requests and
responses to the interface after pulling only
offsetof(struct ieee80211_tdls_data, u) bytes, so the skb can still be
non-linear when the interface work handles it. Drivers that build
paged RX skbs do this for every frame that does not fit into the skb
head, e.g. iwlwifi (mvm), which is also the only mac80211 driver
that sets NL80211_FEATURE_TDLS_CHANNEL_SWITCH. If the remaining data
does not fit into the tailroom, skb_linearize() moves the data to a
new head and frees the old one, and the action code is then read from
freed memory. Depending on what that memory holds by then, the frame
is handled as before or ends in the WARN_ON_ONCE() of the default
case.
The frame only has to be a data frame with the TDLS ethertype from an
authorized peer, e.g. relayed by the AP from another station in the
BSS; the read happens before the sender is checked to be a TDLS peer.
Load tf after skb_linearize(), as the request and response handlers
already do.
Found by static analysis tool CodeQL. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: espintcp: reorder operations within espintcp_init_sk
When enabled on a socket, espintcp sets the socket callbacks to its
own before it has finished setting up its context and published it as
icsk_ulp_data. Any one of those callbacks that gets called before will
dereference a NULL icsk_ulp_data.
Fix this by reording the operations, and add memory barriers to ensure
callers will have a struct espintcp_ctx available. Add a few
WRITE_ONCE/READ_ONCE too while we're there. |
| In the Linux kernel, the following vulnerability has been resolved:
net/9p/usbg: remove bogus context initialization in alloc_requests
alloc_requests() initializes usb9pfs->in_req->context to point at the
struct f_usb9pfs instance itself. usb9pfs_queue_tx() later overwrites
this with the real struct p9_req_t pointer before every transmit, and
usb9pfs_tx_complete() clears it back to NULL after each completion, so
in_req->context only ever holds a valid p9_req_t once a request has
actually been queued.
usb9pfs_clear_tx(), however, can run at any time (mount close, gadget
disable) independent of whether a request was ever queued. If it runs
before the first usb9pfs_transmit(), it reads the leftover sentinel
value, type-confuses the struct f_usb9pfs pointer as a struct
p9_req_t, and both writes through it (req->t_err = -ECONNRESET) and
hands it to p9_client_cb(), which manipulates req->wq and req->refcount
at bogus offsets inside f_usb9pfs. This reliably corrupts memory or
panics whenever the transport is torn down before any 9p request has
been transmitted, e.g. mounting and immediately unmounting, or a cable
disconnect racing the very first request.
usb9pfs->out_req->context is set the same way but is never read by
this transport (usb9pfs_rx_complete() identifies the instance via
ep->driver_data instead), so it serves no purpose either.
Both endpoints' ->driver_data are already set to usb9pfs in
enable_endpoint(), which is what the completion handlers actually use
to recover the f_usb9pfs instance. Just drop the leftover
->context assignments; usb_ep_alloc_request()/alloc_ep_req() already
return zeroed requests, so in_req->context correctly starts out NULL. |
| Incorrect authorization in iOSWeb in Google Chrome on on iOS prior to 158.0.8127.36 allowed a remote attacker leveraging social engineering to bypass web origin policy via a crafted HTML page. (Chromium security severity: Medium) |
| Exposure of sensitive system information to an unauthorized control sphere vulnerability in Tegsoft Yönetim ve Bilişim Hizmetleri Tic. Ltd. Şti. Tegsoft İletişim Merkezi allows Query System for Information.
This issue affects Tegsoft İletişim Merkezi: before latest-202611161510. |
| A vulnerability was found in antirez gguf-tools up to fdfafbed766db0a1e9019b07994cd88f133d1aab. The impacted element is the function gguf_get_tensor of the file gguflib.c of the component GGUF Parser. The manipulation of the argument offset/alignment results in out-of-bounds read. The attack can be launched remotely. The pull request to fix this issue awaits acceptance. |
| Deserialization of Untrusted Data vulnerability in Tribulant Software Newsletters newsletters-lite allows Object Injection.This issue affects Newsletters: from n/a through 4.18.2. |
| Missing Authorization vulnerability in miniOrange miniOrange's Google Authenticator miniorange-2-factor-authentication allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects miniOrange's Google Authenticator: from n/a through 6.6.0. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in Brainstorm Force SureCart surecart allows Stored XSS.This issue affects SureCart: from n/a through 4.13.0. |
| Improper Neutralization of Special Elements used in an SQL Command ('SQL Injection') vulnerability in Tribulant Software Newsletters newsletters-lite allows SQL Injection.This issue affects Newsletters: from n/a through 4.18.2. |
| In JetBrains TeamCity before 2026.2, 2026.1.4 arbitrary file write via read-write file channels in the Kotlin DSL sandbox was possible |
| In JetBrains TeamCity before 2026.2 improper authorization allowed project-limited access tokens to act with full permissions via XML-RPC |
| In JetBrains TeamCity before 2026.2, 2026.1.4, 2025.11.8 stored XSS in the Maven settings health report was possible |
| In JetBrains TeamCity before 2026.2 credential leakage via Mercurial subrepository URLs was possible |
| In JetBrains TeamCity before 2026.2, 2026.1.4 missing authorization allowed users to remove all build configuration assignments from an agent |
| In JetBrains TeamCity before 2026.2, 2026.1.4 unauthenticated extraction of build parameter values via a timing attack on build status icons was possible |
| In JetBrains TeamCity before 2026.2, 2026.1.4, 2025.11.8 reflected XSS on the Build Log page was possible |
| In JetBrains TeamCity before 2026.2, 2026.1.4, 2025.11.8 reflected XSS in the inspection profile selector popup was possible |